1. HOME
  2. ブログ
  3. Can I daisy chain a FireWire hard drive to my MOTU FireWire Audio interface .

Can I daisy chain a FireWire hard drive to my MOTU FireWire Audio interface .

To do this, your graphics card needs to support Multi-Stream Transport . You can include external storage and other laptops in the chain, up to 6 devices in total. Thunderbolt is bidirectional so while your laptop is sending a video signal to an external monitor, the monitor can send power back to charge your laptop. Intel introduced Thunderbolt in 2009 under the code name Light Peak.

What constitutes material change will be determined at our sole discretion. This Agreement will terminate immediately, without prior notice from Music Tribe, if you fail to comply with any provision of this Agreement. You may also terminate this Agreement by deleting the Software and all copies thereof from your computer. Music Tribe may, in its sole discretion, at any time and for any or no reason, suspend or terminate this Agreement with or without prior notice. Music Tribe reserves the right to modify, suspend or discontinue, temporarily or permanently, the Software or any service to which it connects, with or without notice and without liability to you.

  • Studio One Artist is based on a cutting-edge audio engine that delivers 32-bit processing on the fly ensuring high quality audio at all times.
  • If you are still having a problem after you have switched the FireWire driver to Legacy, then the problem may be with the FireWire port.
  • Even the firewire 800 only is a limitation for me, for AV, when I play live ALL my ports are in use, with all my outboard gear powered by the Mac.
  • Misteriously the problems increase by DELL laptops + firewire.

If those virtual cameras don’t capture their images at the same instant, issues like phasing, loss of low-end focus, and digital hiss can become audible. The FireStudio employs JetPLL jitter elimination technology and upgraded converters to combat these common issues, making sure the audio you record is as accurate and musical as possible. For monitoring I sent a few separate headphone mixes – line out 1and 2 went to the bass player and guitarist via a small mixer, line out 3 and 4 went to the drummer via their PA mixer. Thus, I was able to quickly supply them with a custom monitor mix on the spot and save the session settings in the PreSonus FireControl mixer software for recall. From there on I powered up Cubase LE4 and the session ran smoothly.

Mac Pro Daisy Chain Challenge – connected 36 drives (19 Thunderbolt, 15 USB, 2 FireWire with a combined capacity of 100.63TB

Load and save audio clips, MIDI files and, effects by drag-and-drop. You don’t even need a computer to cascade multiple units—simply connect them with a FireWire cable—done! You also can daisy-chain one or more FireStudio-series interfaces with a StudioLive to provide additional inputs for recording. Oh my god, I have spent so much time on this and Presonus tech support couldn’t help after three calls. I installed it on another drive in the same computer running a different operating system- Vista- and it worked, so I figured the device must work. I went back to the Presonus instructions and uninstalled all drivers and every trace I could find in the registry.

The enclosure for your hard drive can be the computer itself , a single-drive external case, or a multiple- drive external case. 2.5-inch consumer drives typically spin at 4200, 5200, 5400 and 7200 RPMs. 7200 RPM drives are a good choice at the moment, but sometimes 7200 RPM drives have too large a power draw or Driversol. generate too much heat for the portable devices in which they are housed. The enterprise-class 2.5-inch drives currently spin at 10,000 or 15,000 RPMs. As part of its specifications, each hard drive has a speed at which the platter rotates, measured in RPMs.

Recommended Firewire Driver Updates

Thunderbolt Networking allows peer-to-peer communication between two or more computers through a Thunderbolt cable. This is useful for resource sharing and moving large amounts of data between computers. If it’s a USB device, Thunderbolt will “fallback” to USB speeds. The USB device may become unresponsive because of firewire drivers download a race condition in the Selective Suspend feature.

Half-duplex means that data is only flowing in one direction at a time, whereas full-duplex would allow data to flow in both directions at the same time. Cable length for FireWire 400 is limited to 4.5 meters (14.8 ft.). Honestly, I have no idea if the issue with the Promise Pegasus R6 drives was ever fully resolved. In the meantime, Apple has released updates to their EFI, Thunderbolt host, device and cable firmware , and USB host controller and audio device drivers. If I had to guess, making the USB host controller / audio device drivers Thunderbolt aware and capable of isochronous bandwidth reservation might have solved the problem. However, Anand’s conclusions about the root cause are different than mine, so I could be way off base.

Will have to watch over a few days so….here’s hoping. These are the numbers that Sonar reported when I view the actual settings. Unlike mix control 3.3 the options on this device are in ms 1ms 2ms 3ms and so on. I don’t see the option that I used to have like short, long, and whatever they used to set the range of latency options, which did have the numbers you describe.

  1. この記事へのコメントはありません。

  1. この記事へのトラックバックはありません。

CAPTCHA


関連記事